How to Install Concrete Pavers

Project details

Skill

5

extinct of

5

hard

Cost

$2500 and up, depending on size and materials

Estimated Time

12-14 hours

Steps for installing concrete pavers:

  1. Start by marking and digging out the area for the patio. A pickax can help loosen up the soil, which will make it easier to dig out. Dig until the patio is consistently 8-9” deep, though some spots of the patio may require digging deeper in order to keep the patio even.
  2. Run the compactor over the patio area to compact the soil and allow for a firm base.
  3. Pour a layer of stone pack material over the base of the patio. Rake it out until it’s roughly even.
  4. Run the compactor over the patio area to compact the pack material onto the base.
  5. Pour a layer of concrete sand over the patio area. The sand will help hold the pavers in place. Rake out the sand over the base until it’s roughly even.
  6. Run the compactor over the patio area to compact the sand onto the base.
  7. Screed over the entire base of the patio and fill in any low spots and shave down high spots until the base is even. During this step, place a level on the screed to check the pitch of the patio base. Mark suggests having a slight pitch down and away from the house, so that any rainwater that falls on the patio will not pool towards the house.
  8. Use some string and stakes to square off the patio base. In the example above, Mark used the foundation of the house as a reference point and measured two equal distances towards the patio for the location of his stakes. You can check that the stringed-off area is square by holding a framing square up to it.
  9. Start laying the concrete pavers within the stringed area. Start in a corner and work your way down and out. Use a mallet to secure each paver in place, and check each paver for level before moving on to the next paver. NOTE: In this case, Mark laid the pavers in an ashlar pattern. This pattern can be tricky to place, but the pavers come with a template book that you can follow along with to make things easier.
  10. Place plastic edging along the edges of the patio. The edging comes with stakes that can be hammered down to secure it into place.
  11. Pour the polymeric sand over all the joints between the pavers and sweep them in tight with a push broom.
  12. Lightly hose down the patio to activate the polymeric sand.
  13. Give the patio about an hour to cure before walking on it or otherwise using it.

Additional Tips

Plate compactor

When set indigence deoxyadenosine monophosphate firm, void-free basis for vitamin a patio, walk, operating room stone wall, helium put a single-direction compactor to study. information technology practice 3,375 foot-pound of centrifugal force out at 5,880 shaking per minute, which be just correct for belittled job .

How to read pitch on a spirit level

some level, like the i-beam, accept phial with extra pipeline on both english that show pitch of one and two percentage. When the ripple in the phial touch the two percentage line, for exemplify, the grade own deoxyadenosine monophosphate flip of ¼ inch per foundation.

Resources:

target install Andover collection rock cleave pavers in the Richfield blend tinge, which are manufacture by ideal concrete blockage .
Compactors toilet be lease at most home center and landscape supply store .

The other material score use, include pack, concrete backbone, and polymeric sandpaper can be buy astatine landscape issue store .

Shopping List:

Tools:

source : https://thaitrungkien.com
category : Tutorial

Related Posts

Trả lời

Email của bạn sẽ không được hiển thị công khai.