As you drill, the navigate snatch will go through first and then the trap experience will drop onto the coat of the wood. Be prepared for this, making indisputable that you are holding the drill hard and that you are fix to stop the drill if the meet gets caught on the wood when it first makes contact. When the hole saw drops down on the woodwind and makes contact, it can get stuck on the wood and wrench the exercise and your hand around alternatively of going through the wood. If this happens, stop the drill and lift up on the see a act. Start the drill again and lightly make contact with the wood so that the saw can work through the wood gradually.

If you cut true through the wood without stopping, it can cause the rear to become jag and rough when the hole saw pops through. To avoid this, cut partially way through the hole and then flip the wood over. Stick the fly piece in the existing fly hole and start saw. 8

Remove the circle of wood from the hole saw. After the cut is completed there will be a circle of forest that is inside the focus on of the hole experience. In many cases you will be able to grasp the edge of it with your fingers and pull it out. however, if the circle of woodwind is amply inside of the hole see, you will need to work a moment hard to get it out. Insert the topple of a flat-blade screwdriver into the holes on the side of the hole interpret and push the forest out with the lean of the screwdriver .